Make sure to test your automations by creating a "dummy" lead that meets the given criteria. Make sure your test leads move through the automation flow as expected. If you have long Wait periods, such as 18 Days, then shorten the Wait period to the minimum delay and test. |
Take care when modifying a running automation. Any modifications could have adverse affects on your prospects. |
Here are a few things to consider:
For actions to apply, the automation must be not deleted, must be activated, and the Prospect must still be in the automation. To remove a Prospect from an automation go to their Prospect Profile page and manually remove them from the automation. To pause all actions in a automation put the automation into a Suspended status. |
Each prospect can be added to an automation only once and each action applies to a prospect only once. If a prospect is removed from an automation then added back to the same automation at a later point then only the un-applied actions (if there are any) will apply to the prospect. Actions will not apply to the prospect again if they were applied to them previously. Consider the following scenario:
For example, consider the following scenario:
|
A prospect is "added" to an automation only one time. For example, if you have three web forms defined in the "Submits Form" Future Event (Step 1) then the actions defined in Step 2 will only be applied one time even if the prospect submits multiple forms. When the first of three forms is submitted the actions will apply. However, suppose the 2nd and 3rd forms were submitted. The actions would not apply again. If you need to notify a lead owner of certain prospect events then we suggest using Buy Signals. Buy Signals will trigger an email and/or text message when specific events occur that are indicative of buying signs. Buy Signals are located under Settings > App Setup > Buy Signals.
Also note, you can come back into a process that is activated and add another action to it. If the prospect has yet to reach the new action step then this action will be applied to them. However, if the new action step is added before the step the prospect is on the prospect will not receive the new action step. New prospects that have not been added to the process will receive all action steps.
All rule criteria in Step 1 of automations run simultaneously. For example, if there were 10 automations and each automation had identical rules in Step 1 then each of the 10 automations would run at the same time. If 5 prospects met the identical criteria then each of the 5 prospects would receive all actions defined in Step 2. |
All filters used in Step 1 can be applied as sub-filters on each action in Step 2. |
It's important to understand how the conditions execute. The best way to explain this is to consider the example below. This automation has four conditions on a single action, the "Distribute Lead" action. Each lead subjected to the automation (as filtered by Step 1) will pass through each condition until a condition is met. In the below scenario, if a lead was in the state of MA then the lead would be distributed immediately via the 1st condition. If the user wanted to distribute any lead whose email contained "pulaskimortgage.com" (4th condition) then they should make the 4th condition the 1st condition; otherwise, the 1st condition would execute on the lead and the 2nd, 3rd and 4th conditions would be skipped.